I’m installing laminate flooring in my room,
and I don’t know how to install the Quarter round…
The problem is:
I don’t want to ruin the floor when taking out the spacers..
Help!
cut your piece(s) to length, miter ends if necessary
paint them (it’s easier to do before you emplace them)
place it in
nail it with a finishing nail into the baseboard, NOT the flooring. Use a nailset when finishing the final few taps so you don’t mar the paint.
Drive the nail in slightly past the wood
fill the hole with putty, let it dry, sand it down
touch it up with paint.
If you have to join two pieces to make a long one, cut each end at a 45 degree angle (opposing angles so one will overlap the other) just follow all steps and mask the seem with putty, sand it, then touch it up with paint.
5 comments ↓
Use small finishing nails and nail it to the baseboard. That way the laminate flooring can expand and contract if it needs to. I have also glued some down when in tough spots to nail.
References :
properly installed, you should be able to pull the spacers no problem. you can use your pull bar GENTLY to free any spacers that are stuck by tapping the whole floor the other way.
you can use a baseboard instead of quarter round if you like, but you will use small brad or finishing nails to fasten the trim to the wall just above the laminate. when you are done there should be a gap between the laminate, the baseboard, the wall and the subfloor, and the laminate should be free to move.
References :
cut your piece(s) to length, miter ends if necessary
paint them (it’s easier to do before you emplace them)
place it in
nail it with a finishing nail into the baseboard, NOT the flooring. Use a nailset when finishing the final few taps so you don’t mar the paint.
Drive the nail in slightly past the wood
fill the hole with putty, let it dry, sand it down
touch it up with paint.
If you have to join two pieces to make a long one, cut each end at a 45 degree angle (opposing angles so one will overlap the other) just follow all steps and mask the seem with putty, sand it, then touch it up with paint.
References :
Use a wider based baseboard and forget the 1/4 round.
Spacers should be removed if it is a floating surface.(no glue)
References :
all these answers are good but i would ad before you try to nail them in place set them up on your work surace predrill them judge the angle angle direction to hit the base board a drill size would be establish in a piece scrap would as a hole that would be a snug fit for the finish nail you will be using
it will make applying it much easier
References :